INSTALL INSTRUCTIONS C-TSM-CHGR-X
TRUNK SIDE MOUNT FOR 2006-2008 DODGE CHARGER
X = “D” DRIVERS SIDE OR “P” PASSENGER SIDE
TOOLS REQUIRED:
Ratcheting wrench
Screwdriver set
Utility knife or Jig Saw
Powered drill w/ 1/8” & 3/16” drill bits
HARDWARE:
QTY DESCRIPTION
PART #
3
3
3
10-32 Keps nuts
10-32 x ½” Phillips machine screws
#10 x ¾” Sheet metal screws
GSM30028
GSM33118
GSM33195
Always!
ꢀ Read all instructions before installing any Havis-Shields Equipment Corp products.
ꢀ Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
ꢀ Use hardware provided with install kit
Empty view of passenger
side mounting location
Notch trim as necessary
Note: Vehicles w/ carpeted
fiberglass trim requires more
cutting due to thickness of material,
see next page.
Position trunk side mount and
determine where to notch vehicle trim
in order to function properly
Pre-drill lower mounting holes
using 1/8” drill bit and attach with
#10 x ¾” Sheet metal screws
Cut carpeted fiberglass trim along
this line for proper fit.
Position Trunk Side Mount and
mark (3) holes on top mounting
|
Briggs Stratton 54000 User Manual
Briggs Stratton 137200 User Manual
Brother PT 9400 User Manual
Canon Printer H12 4606 User Manual
Friedrich M36CF User Manual
Fujitsu RY 36UA User Manual
Graco Ultra Clear 1750483 User Manual
Haier AS072AZNDA User Manual
Haier HSU 12HEK03 User Manual
HP Hewlett Packard Hewlett Packard All in One Printer L1945WV User Manual